TTSaleen
Active Member
- Joined
- September 17, 2013
- Messages
- 73
- Reaction score
- 61
- City, State
- Apex, NC
- Year, Model & Trim Level
- 2003 Explorer XLT
Recently my transmission was rebuilt.
However since getting the Explorer back, it is not consistent going into gear.
Example - When I pull the shift lever into Reverse, it may go into gear 4 out of 5 times.
But the 5th time, it wont' be in gear and revs like in neutral.
I then have to pull it down to Drive and push it back to Reverse for it to engage properly and move.
I've also had it feel in-between gears when shifting to Drive (4th) and to remedy I've had to pull it down to 3rd and push it back up to Drive.
Then it feels right and takes off and shifts properly.
I've crawled under it and adjusted the shift linkage a few times but I cannot get it resolved.
Again it will shift fine about 3 to 4 times out of 5.
It's more aggravating than anything.
Any suggestions or did the transmission shop do something wrong when they had it apart?
NOTE - It never had this issue prior to the rebuild.
Ryan
However since getting the Explorer back, it is not consistent going into gear.
Example - When I pull the shift lever into Reverse, it may go into gear 4 out of 5 times.
But the 5th time, it wont' be in gear and revs like in neutral.
I then have to pull it down to Drive and push it back to Reverse for it to engage properly and move.
I've also had it feel in-between gears when shifting to Drive (4th) and to remedy I've had to pull it down to 3rd and push it back up to Drive.
Then it feels right and takes off and shifts properly.
I've crawled under it and adjusted the shift linkage a few times but I cannot get it resolved.
Again it will shift fine about 3 to 4 times out of 5.
It's more aggravating than anything.
Any suggestions or did the transmission shop do something wrong when they had it apart?
NOTE - It never had this issue prior to the rebuild.
Ryan