redshoesyo
New Member
- Joined
- February 13, 2008
- Messages
- 5
- Reaction score
- 0
- Year, Model & Trim Level
- 1998 mountaineer v6 4wd
Long story short my 4wd low engages but my 4wd high does not. The dash indicator lights up when switched into 4wd high but there is no affect on the front axle and no sound from the tcase. In snow the rear tires only spin when in 4wd high, ive done a few parking lot test both in and out of the car to confirm this as well as the tests involving having the front jacked up in 4wd and spinning the drive shaft/wheels.
However, when put into 4wd low there is a solid clunk of the transfer case engaging and the system works as it should.
I have checked all fuses and relays, replaced the BCM behind the radio, checked electrical connections at the transfer case and tcase motor and all remains the same.
Any advice on where to go next? What would make 4wd high not work but allow 4wd low to? Any advice is appreciated.
However, when put into 4wd low there is a solid clunk of the transfer case engaging and the system works as it should.
I have checked all fuses and relays, replaced the BCM behind the radio, checked electrical connections at the transfer case and tcase motor and all remains the same.
Any advice on where to go next? What would make 4wd high not work but allow 4wd low to? Any advice is appreciated.