audiodude332001
Well-Known Member
- Joined
- July 15, 2003
- Messages
- 842
- Reaction score
- 0
- City, State
- Eau Claire,WI
- Year, Model & Trim Level
- 2000 explorer 5.0
Hey everyone. Been a while since I was on here last but I need some help. Got a 2000 5.0 with awd. Replaced all balljoints last week, cranked the torsion bars and put shakles in the rear. Put 31" Goodyear wrangler duratracs on it and got it aligned. After all was done, I'm getting a nasty vibration when on the throttle. Removed the front driveshaft and the vibration went away. Put a new driveshaft in it and still get the same problem. Can't figure out what is causing this. Planning a 4406 swap in a few weeks and hope the vibration doesn't stay after the swap. Any ideas?