explorer cranks but won't fire

[exploder09]

I have a 94 explorer i just removed the ac out of it, and now for some reason it won't start, i've checked all apparent vaccum lines and the grounds on the fenders. i replaced the ecm relay, checked fuses, checked fuel pump shut off switch it seems like i'm getting fuel pressure. The wierdest thing is i removed the ECM controller or the EGR i'm not sure which one it was( it was the one near the washer fluid and anti freeze canisters) it started for 5 minutes but had a huge vaccum leak while i was trying to find it the engine cut out and would not start again. Any suggestions please help this is my only way to work and back.!!!

 

[cjones101812]

the EGR valve is mounted on the engine the ECM connector is on the firewall by the master cylinder, so i couldn't tell you what you removed without a pic of it.

with a huge vacuum leak a missing/disconnected hose should be obvious.

 

[exploder09]

the EGR valve is mounted on the engine the ECM connector is on the firewall by the master cylinder, so i couldn't tell you what you removed without a pic of it.

with a huge vacuum leak a missing/disconnected hose should be obvious.

it was the ECM connecter it fired right up but then died out 5 mins after

 

[exploder09]

Problem was fixed, turned out to be a loose wire to the battery (the only place we didn't look like dumbasses)