New member needs help

[Ray Lobato]

I got this from a new member who needs help with timing.
I thought some of you guys could point him in the right direction.
Thanks,
Ray

I have a 96 explorer that i had to put a motor in back in April. the motor I put in it was from a 94 explorer. I had to take the intake, the wiring harness, and the camshaft positioning sensor from the 96 block and put it on the 94 block. the 94 motor had a dummy shaft where the camshaft positioning sensor #went. because I swapped the wiring harness I had to use the camshaft positioning sensor out of the 96 and put it in the 94 block,for computer reasons. now to my issue, I have no clue how to time the camshaft positioning sensor to the block. if you can help me it would be greatly appreciated.

 

[Ray Lobato]

Bump for some help

 

[Tbars4]

...These are the best I can find so far...Hopefully they will help...

http://www.explorerforum.com/forums/showthread.php?t=245692&highlight=cps

http://www.explorerforum.com/forums/showthread.php?t=114484

http://www.explorerforum.com/forums/showthread.php?t=241555&highlight=cps