LOCKONS7RA7US
Active Member
- Joined
- August 14, 2015
- Messages
- 81
- Reaction score
- 5
- Location
- Everett , wa
- City, State
- Everett washington
- Year, Model & Trim Level
- 1992 , eddie bauer
- Callsign
- Taco Run
so lately i have been having the issue of when i go start me explorer starts fine and idles fine , cranks over and after it gets to temp and go to put it into reverse it will just die and stop idling and will have to put it in park and start it over again . I can get it to go if i goose it with the gas and then try to put it in drive but then it will die if i put it in drive . but its super inconsistant and sometimes living on a prayer it wont be a mad at me and will be fine . i think its gotta be some type of internal electronic part in the trans due to the fact that it idles and starts fine and will run an drive fine if you catch her on a good morning or day . but the fact is that as soon as i put it motor on a load ( meaning i put it in a gear ) that it dies in gear . i plan on getting the trans serviced here soon and just already went through this for other reasons
Fuel system - new gas sending unit in the tank
New starter , new MAS , new battery , new alternator , new stater solenoid , new high temp silicone vacum line ( including the trans vac line )
im ganna replace the fuel filter under the car but im kinda just going over and open for feed back on what this could possibly be and if its something cheap and stupid that i havent looked into yet or the trans is just taking a crap on me or something
Fuel system - new gas sending unit in the tank
New starter , new MAS , new battery , new alternator , new stater solenoid , new high temp silicone vacum line ( including the trans vac line )
im ganna replace the fuel filter under the car but im kinda just going over and open for feed back on what this could possibly be and if its something cheap and stupid that i havent looked into yet or the trans is just taking a crap on me or something