no power

I have a 1997 Explorer with the 4.0 SOHC. I have recently had the timing chains replaced and has been running fine now for a couple of weeks. A couple of days ago, about 10 degrees out. Upon attempting to start the vehicle, I would here nothing but a loud click. I attempted to start it too many...

Hello, Hope I'm posting this in the correct place. There are many threads similar but none that Ive found address my particular issue. I have a 2002 Explorer XLT. The shift cable went so I replaced it myself. When I put it all back together the ignition turns and all but there is absolutely no...

My 1994 Ex XLT all of a sudden acts like it is out of gas and it isn't. Starts losing power and have to get to the shoulder fast. I toy with it for awhile, giving it gas and trying to keep it running the finally it takes of again for a few days. I have pulled the codes but am having trouble...

Alright so all of the sudden my 00 Explorer (4.0 SOHC) has been running like garbage. It started when one of my cats got plugged (it sure shined a nice cherry red). Since then, I have replaced plugs, plug wires, and coil. They didn't help so I replaced the Crank position sensor now too. The...

My exployer has been running fine, went to store come out it started rite up but when i put it in gear and went to accelerate it just skips,sputters and finally cuts off. Revs up in pary but real slow and onlly about 3 to 4k rpm's. Engine lite is also on I ckeck map and it was clean and all...

I have a 92 Ford Explorer XLT 4WD with a 4.0 liter automatic it ran great no problems then about a month ago my husband cranked it up but wouldn't run over 35 mph, it doesn't have any power. He was able to drive it around the park but thats it. Thought it was fuel pump but the pump sounds like...

Hello! I have a 1998 4.0ohv 4wd. Recently I got the p1309 code and also the p0171,p074 bank 1 and 2 lean codes. I proceed to change out the Cam Position Sensor and syncro. I did them both correctly exactly by the book. Made sure to put the engine at top dead center ect. I reset the computer (...

I write this while hanging my head in shame at my foolishness. Tonight I decided I would remove my factory CD changed in the console and wire up some power outlets from the wires in the harness... or at least determine if that was possible. So as I was working I'm listening to my AFTERMARKET...

I have a 2003 Mountaineer 4.6L with 151,000 miles. I'm a good home mechanic, but this has me baffled. I recently replaced the intake manifold and had to correct a few minor issues, but it ran and drove fine for several days. Suddenly, very abruptly, I started having a lack of engine power. I...

I'm pretty sure I am having a problem because of a malfunctioning anti-theft system (I don't believe it is aftermarket). I seem to have a slightly different problem than other threads that I've seen on this sight. A few days ago, I unlocked the driver side door with the key, opened the door and...

I'm sure there's probably been a lot of posts that talked about the Blend door actuator but I never got the answer. So, guess this will be another one. My question: why is there no power going to the blend door actuator in my 2001 Ford Explorer even if the fuses are good? Please help! Spent...

No codes. Have replaced IAT, ECT and TPS. New plugs and wires 10,000 miles ago. Started runing rough. Checked plugs and rt bank plugs burnt off. Replaced those plugs. 500 miles later, running rough, checked plugs and rt bank plugs starting to deteriate again. Replaced and engine will...

Hey guys.. I 've been sayin that I had a small exhaust leak it, it sounded more like a "flutter" cause the compression was finding this "leak".no one else could hear it &Thought I was nuts,had to go outta town last week for 2-days, 502 miles one way.About 150 into it, I found out I now have...

I got into my '99 Explorer Sport this morning and turned the key like I always do when the car just stopped all functions, no power running through it at all. It turned over once and then completely shut down. no radio no windows can't even lock or unlock the doors, I don't know whats wrong with...

I have a 4x4 2002 X V6 130,000. was driving 70-75 on freeway and had a loss of power. Has rough idol revs high and shifts fine (but still shifts through all gears) accelearates extremly slow. will not go over 40 (unless going down hill). starts fine, does not stall, has rough idol, will go into...

02 4.0 171k miles No Power Had misfires so I went down the list and Replaced Plugs Replaced Plug Wires Replaced Coil Replaced Air Filter Replaced Fuel Filter Cleared CEL It's a little better but still has rough idle, VERY sluggish especially up hill, no CEL even after 100 mile trip...

i have a 92 explorer 4x4 with lost of miles and a long story short i hydrolocked it off roading. i got a 90 ranger 4.0 engine as a doner. had the heads done at the machine shop, valve job, resurfsed, the block i did nothing to, the cylinders had fresh cros hatches on all of them, with no lips...

Hi guys. I'm posting this, but figured out the problem. Hopefully this will help someone else out. I have a 2002 XLT & Just replaced the battery on Tuesday. My daughter drove the truck all week with no trouble & then this morning (Sunday) it wouldn't start. It wouldn't take a jump from my Ford...

Hello everyone Im brand new to this site, I joined because mechanics have taken almost $1,000 from me and I have the same problem, and in hopes that someone here can help me. I have an '02 Mountaineer, 8 cyl, 4.6, AWD. When I drive and go uphills I loose power and wont really go faster...

My truck sat for 2 years so I figured i would sell it. So i went and charged the battery and now i have no power to anything. I checked the fuses they look fine. Any help would be great. Thanks

i have a 2002 ford explorer with less than 80k miles on it. last week i went to turn the engine and it was met with a fast clicking sound. i had a new battery put in and everything was fine until tonight when i went to start the car and now there is no power at all! no lights the dash or...

okay so heres the deal, this is a completly stock truck, 93 ex limited 4x4 and all the goods, only things ive done is new plugs/wires, and audio stuff, ol girl ran out of gas, i got it going again, and now if i need it to "**** and get" the engine just kinda sputters and i roll away slowly, if...

New member here. Since the purchase of my mountaineer I have been exploring the Explorer forums for a couple of months and have found many useful tips on my MACH Audio, door locks, and some other things. Many thanks to all who have made this possible. Now for some fun, Codes Codes. Left side...

Hello all, this is my first post to the forum. I have read many threads and can not find what I need so here goes. I picked up a 1992 Explorer xlt with the 4.0 l OHV last month for a pretty good price from the original owner. I have since replaced the leaking valve cover gaskets, installed a...