4.0 Exhaust Clip Thread ! | Page 5 | Ford Explorer Forums

  • Register Today It's free!

4.0 Exhaust Clip Thread !

Just got a new exhaust installed. Holley Hooker Headers Max Flow

http://www.holley.com/types/Maximum Flow.asp

Cost me $65 shipped. Its the offset in/single out muffler. Single each side. I bought it for:

1)Fuel Mileage. Flow through design helps with power/fuel economy
2)Deeper/louder sound

This muffler sounds pretty good. No drone crusing/highway, but this baby gets pretty loud when on the gas. Noticable power increase compared to the turbo muffler I had on before. Nice investment Id say!

Sounds almost exactly what i'm looking to get from my exhaust...can you work on getting a video or a sound clip?
 



Join the Elite Explorers for $20 each year or try it out for $5 a month.

Elite Explorer members see no advertisements, no banner ads, no double underlined links,.
Add an avatar, upload photo attachments, and more!
.





Has anyone who is running straight y pipes had any problems with removing the sensor in the Cat just before the muffler? I was wanting to cut off the cats and run just the y pipe untill I can get to my uncles shop to weld up a Flowmaster 40 series, but dont want any check engine lights or bad gas milage
 






Sounds almost exactly what i'm looking to get from my exhaust...can you work on getting a video or a sound clip?

I wish I could but I do not have a dig camera at the moment. I will see if I can borrow one soon
 






Has anyone who is running straight y pipes had any problems with removing the sensor in the Cat just before the muffler? I was wanting to cut off the cats and run just the y pipe untill I can get to my uncles shop to weld up a Flowmaster 40 series, but dont want any check engine lights or bad gas milage

I am only using 2 out of the 4 02s. I had the 2 02s right before the muffler turned off with a tune. Removing this without turning them off/tricking the computer WILL cause a CEL.
 






what is the eaisiest way to turn it off, I have to take it to the dealership to thve a recalled cruse control sensor replaced, is this somthing they can do??
 






what is the eaisiest way to turn it off, I have to take it to the dealership to thve a recalled cruse control sensor replaced, is this somthing they can do??

I highly doubt the dealer will do this. To me, its like asking them to take the cats out. Its there for emissions and such so they probably will say sorry Easiest way is to get a tune done from Bama Chips, or the like, or search for 02 sensor CEL eliminators. Custom exhaust shops can do this for you
 












here is the video of mine


NOTE: 1998 SOHC Vortex muffler from cherry bomb (88107 or 88106) had resonator removed and replaced with piping, and the ebay's verison the the KKM. sounds nice and deep (for a v-6) not ricer at all, not too loud but you really know its not stock
 






Doesn't sound too bad at all. I'm sure the video doesn't do the sound justice at all. I've been following this thread closely lately as I am looking to upgrade the exhaust on my Frontier, I know its a different motor and all, but its still a 4.0, only that this one is DOHC. Its going to be hard to find the sound that I want and not be too loud. Nice work though.

Dan
 






sounds nice
 






Doesn't sound too bad at all. I'm sure the video doesn't do the sound justice at all. I've been following this thread closely lately as I am looking to upgrade the exhaust on my Frontier, I know its a different motor and all, but its still a 4.0, only that this one is DOHC. Its going to be hard to find the sound that I want and not be too loud. Nice work though.

Dan

ya mine sounds pretty much like yours, it sounds a little deeper then it does in the video, some times 2500k rpms it has some loud resonance , but thats when i think it sounds the best

just noticed when i turned my bass all the way down it sucked so if you can turn your subwoofer/bass up to max and thats what it really sounds like
 












Sounds good! I like it. I wish I had a camera to tape my new exhaust
 






jd0gg u going to post a new sound clip of dual straights
 












Flowmaster super 40 or a Cherry Bomb pro or extreme

Which muffler would you decide on the Flowmaster super 40 or the cherry bomb pro or extreme. I am looking for a throater v8 sound and i have a V6 sohv engine.
 






Which muffler would you decide on the Flowmaster super 40 or the cherry bomb pro or extreme. I am looking for a throater v8 sound and i have a V6 sohv engine.

On my truck, OHV, the Cherrybomb gave me a deeper sound than the Flowmaster. The SOHC is going to sound a little different though.
 






Which muffler would you decide on the Flowmaster super 40 or the cherry bomb pro or extreme. I am looking for a throater v8 sound and i have a V6 sohv engine.

go on you youtube and search a bunch of video's with those "type brands"
 






I got dual 40 series flows and i love it
 



Join the Elite Explorers for $20 each year or try it out for $5 a month.

Elite Explorer members see no advertisements, no banner ads, no double underlined links,.
Add an avatar, upload photo attachments, and more!
.





Which muffler would you decide on the Flowmaster super 40 or the cherry bomb pro or extreme. I am looking for a throater v8 sound and i have a V6 sohv engine.

they dont make the pro or extreme for the sohc (dual inlet) thats why i went with the vortex
 






Featured Content

Back
Top