Boy447374
New Member
- Joined
- June 8, 2018
- Messages
- 5
- Reaction score
- 0
- City, State
- Richmond, IN
- Year, Model & Trim Level
- 2002 Ford Explorer XLT
I'm putting in a used transmission on my 2002 explorer 4x4. When I put the torque converter on the transmission shafts, the torque converter is sliding back so far as it rubs on the back of the bell housing. Of course when I bolt the torque converter back up to the flexplate it will pull the torque converter off the back of the bell housing... but is this normal for the torque converter to slide on that far? My old transmission (the one i'm replacing) does the same thing. There is about an inch sticking out on the inner shaft.