about a year ago i cut the wires to my old fog lights and installed new ones in the stock location, the new ones are the SAME watage as the old ones. I spliced the wires with the correct connectors and everything is taped like crazy to make sure its watertight. i did everything the right wayand its not like its wire nutted together or anything but 2 days ago i noticed they werent on. so i changed the fuse becuase it was blown, i drove it and ten minutes down the road the fuse blew again. i relplaed with a 20 amp fuse the third time instead of 15 just to see, and it blew right away.
btw i am using the stock wiring harness i just spliced in the new lights.
So any ideas on why it keeps blowing fuses?
btw i am using the stock wiring harness i just spliced in the new lights.
So any ideas on why it keeps blowing fuses?