Spdrcer34
Explorer Addict
- Joined
- March 14, 2002
- Messages
- 3,873
- Reaction score
- 13
- City, State
- Bremerton, WA
- Year, Model & Trim Level
- 1992 Explorer XL
I am a skilled welder, and body man. I have read EVERY thread I could find on the installation of a Rollpan. I haven't found much information at all on the 1st gen. rollpan install. I know about the frame mods, I am comfortable doing them after seeing the mods done in a few threads.
I will use a Steel rollpan, but I am concerned about fabricating some 'corners'. Could I cut some bed corners off of a Ranger, and make the bodylines match? Or am I better off using an early 90's F-150 rollpan and cutting it down. I know anything is possible, but I'd like to make it look good.
Ryan
I will use a Steel rollpan, but I am concerned about fabricating some 'corners'. Could I cut some bed corners off of a Ranger, and make the bodylines match? Or am I better off using an early 90's F-150 rollpan and cutting it down. I know anything is possible, but I'd like to make it look good.
Ryan