pcm

I have 99 explorer sport with an sohc recently converted to manual with the m50d. Ive tried leaving the solenoids plugged in to fool the pcm but the tranny codes always come back. my question is which model/year fords will have a pcm that will be plug and play? ive been told that a 2001 ranger...

hello my fellow ford lovers, I just converted my 99 sport to manual. I bought the truck for the conversion. everything seems to be good how ever I keep getting the solenoid codes and this wont allow me to past e-test here in Ontario Canada. I just bought a 2004 ranger 4x4 pcm programed for...

Had two diagnostics, 1st said PCM O2 side no voltage coming out. took to dealer with replacement PCM, said not computer; still running on original. 2nd dealer diag said truck old, timing belt is my ping kinda noise, also said compression checked twice cyl 2 and 4 gave low then normal value. One...

So I've done some research, but I think I've read too much and confused myself. Truck is only $200 bc the guy has lost his keys and I talked him out of junking it. Problem is it's PATS equipped I believe. I'm new to PATS as my '97 explorer isn't so equipped. I'm thinking of just changing out...

I can't get an emissions certificate. I had a failed PCM replaced at the Ford dealer over 2 weeks ago. I have about 5 sensors that are failing readiness set. Is there some special driving cycle I need to go thru to get the sensors to go to ready? 2002 Ford Explorer XLT 2-wheel drive 4.0L

hi all, over the summer i did the BWM all has been good up until recently. with all of this snow i have been noticing that the transfer case is not engaging the front axle and i am constantly in 2WD. with this said i have a 2004 explorer 4.0 V6. my question is how does the PCM know when to...

Situation: My explorer starts up, warms up, I drive it down the street and it starts stalling on me sporadically. Sometimes it will die and I pull it over (it is consistently starting right back up afterwards), and sometimes it will stall and keep running but act like its trying to die for a...

First, I want to say hello! First time Registering. Love this site, and has always been extremely helpful! I have a Transmission Solenoid problem. First, I was getting an error code of P0751 for Solenoid SS1/A. I replaced the whole harness and Solenoid A and car worked for a little while...

Need help on my 2002 ford explorer. no power to starter solenoid. Replaced stater/solenoid due to corroded wire between solenoid and starter. Still no power. Ran a jump wire to solenoid, but won't start...will turn over. I am getting power all the way to the starter relay. Swapped relays but...

people, i need the harness(wires) from abs to pcm, somebody know where can buy? explorer 1998 sohc 4.0 xlt

I have an 06 Explorer. Suddenly have no reverse. No warning signs, leaks, lights, codes, etc. All other gears work including 4 hi & Low. When I put it in reverse, the car doesnt move. If I give it gas, the engine hesitates for a brief moment, then the rpms increase (as if I was in...

I have a 93 explorer 4.0 OBD I it will start fine drive down the road and it wants to bog down with the pedal to the floor and the check engine light comes on. Now when it hits 3000 rpm the light goes off and it opens right up and seems fine. At the next stop sign or light same thing happens...

Alright so after changing a ton of stuff I borrowed the computer out of my brothers ranger and now mine seems to be running alright. I need to get one of my own and I was wondering what the best is? Can I gain any fuel mileage in my OBD1 94? Would using a OBD2 computer do me any good or...

i ran some trouble codes on my 1992 explorer and i got a code 513,114 and 116, i looked up a 513 and it says pcm internal voltage failure does that mean i need a new one? and also my explorers fuel injectors seems to be putting out a rich mixture of fuel. i pulled all spark plugs and checked...

Having trouble getting my 95 explorer 4.0 start. The starter is firing and the plugs are also firing. I have no pressure at the shrader valve. I changed the fuel filter and while the filter was off i turned the ignition to on position and can hear the pump working yet no fuel comes out of...

I made the transmission swap to the m50d 5 speed and kept the tranfer case. all mechanically is sound, but i cannot get the engine run right. it cuts out at about 2500 RPM and runs really louwsy and loss of power. I did: keep the engine hanress the same, wired CPP switch acording to wiring...

I made the swap with the m50d 5 speed and kept the tranfer case. all mechanically is sound, but i cannot get the engine run right. it cuts out at about 2500 RPM and runs really louwsy and loss of power. I did: keep the engine hanress the same, wired CPP switch acording to wiring diagram...

hi everyone, im a young guy and have very little experience with performance off-roading vehicles. i need some help figuring out what type of performance pcm modifications to do. my suv is a 1991 explorer eddie bauer 4dr 4wd. the modifications that i have done so far are headers, performance...

Power is getting to the computer and chec engine light does not come on with key turned.

an ex with 21k that just needed PCM/TCM reprogrammed? Posted previously about my 02 Ex that Ford couldn't figure out, so now I just decided to buy a different one, a newer one. Found a 2007 Limited with V8, 21,000 miles, but upon reviewing the service recs, found it has just had the PCM and...

Posted previously about my 02 Ex that Ford couldn't figure out, so now I just decided to buy a different one, a newer one. Found a 2007 Limited with V8, 21,000 miles, but upon reviewing the service recs, found it has just had the PCM and TCM (it listed both) reprogrammed, because during a...

This is a new one for me. My wife took our daughter to school the other morning, came home for an hour, went to start the truck again and it was dead. No chimes, no radio...nothing. I came home that night, tested the battery charge and it was as dead as it gets. Time for a new battery anyway, so...

Hi all, first time posting here, but I'm going absolutely mad. Have a 1992 Aerostar XLT (4.0L, E4WD) that has been passed down through a couple generation in my family. My grandmother got it new, gave it to my mom about 5 years ago. She wrecked it, got it fixed up new, then the alternator died...

My 1994 Explorer will not start. I checked the inertia switch it is closed and good. Checked fuel pump relay coil is good, relay changes state with 12 dc applied to the coil, and the normally open path closes with 12vdc applied to the coil. So like a fool I replaced the fuel pump. Truck still...

The EEC-V on my 97 mountaineer 5.0 is fried. I don't want to spend over $150 at a parts store. the four letter code on mine is SLL3 the part number is F67F-12A650-TD my question is, can I simply pull a computer from ANY 5.0 Mountaineer, or do one or both of these codes have to match.