kevin360
New Member
- Joined
- July 6, 2015
- Messages
- 6
- Reaction score
- 0
- Year, Model & Trim Level
- 2006 300C AWD
I have a 2013 Explorer Sport that has factory remote start and push-button start. I recently bought kit CL3Z-19G364-B off ebay and installed it. The kit comes with the VSS, long range antenna, and two 1-way FOBs. Kit works fine, I'm able to remote start the car with the 1-way FOBs.
I would like to have a 2-way FOB though, so I purchased the 2-way FOB (DL3Z15K601A). Problem I'm having is how to program it. Most of the instructions I come across are for cars that DON'T have push-button start. I've tried these instructions:
55. Push Button Start Vehicles:
NOTE:
These steps must be performed with the VSS module security jumper removed if previously
installed. For additional information refer to "VSS Module - Optional Vehicle Security Features".
1 Enter the vehicle with the vehicle key(s) and key fobs you wish to program.
2 Depress and hold brake pedal.
3 Press the start/stop button.
4 After the vehicle starts press the start/stop button to shut down.
5 Repeat steps 3 and 4 an additional four times, ending in ignition on, engine off.
6 Release the brake pedal.
7 Press the vehicle start/stop button twice to turn ignition on.
▪ The horn will honk 3 times to indicate transmitter learn mode access.
8 Press the start stop button on each fob you wish to program.
9 Cycle ignition to the OFF position to exit transmitter learn mode.
From page 27 of the pdf here.
But so far no luck. The jumper was not installed in the VSS, the kit actually didn't have a jumper to install into the VSS. Anyone know how to program the new FOBs?
Thanks,
Kevin
I would like to have a 2-way FOB though, so I purchased the 2-way FOB (DL3Z15K601A). Problem I'm having is how to program it. Most of the instructions I come across are for cars that DON'T have push-button start. I've tried these instructions:
55. Push Button Start Vehicles:
NOTE:
These steps must be performed with the VSS module security jumper removed if previously
installed. For additional information refer to "VSS Module - Optional Vehicle Security Features".
1 Enter the vehicle with the vehicle key(s) and key fobs you wish to program.
2 Depress and hold brake pedal.
3 Press the start/stop button.
4 After the vehicle starts press the start/stop button to shut down.
5 Repeat steps 3 and 4 an additional four times, ending in ignition on, engine off.
6 Release the brake pedal.
7 Press the vehicle start/stop button twice to turn ignition on.
▪ The horn will honk 3 times to indicate transmitter learn mode access.
8 Press the start stop button on each fob you wish to program.
9 Cycle ignition to the OFF position to exit transmitter learn mode.
From page 27 of the pdf here.
But so far no luck. The jumper was not installed in the VSS, the kit actually didn't have a jumper to install into the VSS. Anyone know how to program the new FOBs?
Thanks,
Kevin