The project was MUCH easier than I expected.
The back took my friend and I less than an hour for both sides from start to finish.
The front took about two hours.
Heres the process as best as I recall.
Remove rear tire
Remove top and bottom stabilizer bolts....holds short 6" rod
Remove shock bolt
Remove lower control arm bolt
Remove Spring
Reverse process
Remove front tire
Remove upper swaybar bolt
Remove both lower strut bolts....after removing nut....punch bolt out as it is splined and pressed in.
Remove four nuts on top of shock tower.
Remove strut
Compress spring, remove nut from the end and remove from strut
Install new spring, compress and put nut back in top of strut
Reverse process
Sport looks mean.....not slammed.....coupled with 1" spacers front and rear really looks sharp.