Camshaft position sensor

[mechanized]

Hello,

I have read some of the posts on the site in regards to the CPS and think that might has something to do with my stumbling and misfire issues like I have described here. http://www.explorerforum.com/forums/showthread.php?t=232863

I had a squealing sound coming from the top of the engine start about 2 and half weeks before my trucks issuses started. I replaced the upper idler pulley thinking that was it because of the 222K miles on my truck. That didn't stop the squeak so I assumed it was the water pump but haven't changed since there are no leaks and it keeps the temps in check.

I went to Advanced to pick up the whole Sync and CPS sensor and tool today but they told me there are two different part numbers. The part is a remanufactured unit from Cardone. One is Part# 30-S2800 (with step on plug) and the other is 30-S2800L (without step on plug) Which one is correct? Has this cleared up anyone else's truck problems other than the squeal?

 

[mechanized]

OOOPS! Don't know How I posted that twice. Sorry

 

[Turdle]

This may help-
I think 99 -up use a 2 pin connector, where earlier has 3. So, you may be able to match it up if you look at the connectors on each

 

[mechanized]

Yes you are right, but both of these part numbers are for a two wire '99.

 

[Turdle]

I would have them order both in. Take your sensor in to match it up.

Just take the sensor cap itself off real quick and take it there with you.

 

[mechanized]

Cool, works for me

 

[Cobraguy]

See if they can't use their Buyer's Guide and show you the difference. (It's a catalog that shows pictures, gives specs, etc.)

 

[Mikeri]

I replaced mine almost 18 months ago using a Dorman part and have had no problems. The Dorman rep was very helpful; as I was sent the incorrect part. As an aside, I was worried after installation that the part did not match up exactly with my scribe mark. No problems, and I don't think about it any more. A few others have had the same situation.