Carlovers Desert Beater Build | Page 36 | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

Carlovers Desert Beater Build

Well im starting to source parts and gather up some good stuff. I figured id start a thread just to show everyone that the ideas are. Should be a pretty fun setup when done. Everything will be being built by Brandon at BTF Fab.

The rear will be a 4 link with a panhard bar and cantilever coilovers. Shooting for around 20" of rear travel. Full size van 9", and should be around 3.5" wider per side than stock

Front will be a BTF front setup more than likely with a fully fabbed spindle with d44 hubs and uniball upper and lowers. Should pull around 16-17" of travel. Will be around 5" wider a side than stock.

It will be a fairly slow build due to finances. It will be built in stages obviously and should take around 12-16 months to be fully complete.
 






just started reading this thread yesterday and by the time I got to the end it felt like I was reading old yeller... incredible build good luck with the bronco!
 






Back
Top