ranger-93
Well-Known Member
- Joined
- March 15, 2009
- Messages
- 270
- Reaction score
- 0
- City, State
- Fayetteville, GA
- Year, Model & Trim Level
- 93 ranger, 01 f-350
I need some help with rebuilding my shift motor. All the contacts are good, cover plate is lined up which I verified by using a meter. I have tried using vinyl tubing for the washer stop and it jus damaged it becuase it would just run over it. Tried using polyurethane tubing...spelling?... which is a little stiffer and the same thing happens, just ran it over too. It will go into 4 wheel high fine but when I stop clutch in brake on in nuetral and hit 4x4 low it just clicks a few times and kicks itself completely out of 4x4 all together. At this point Im pretty lost on what to do other than buy a new shift motor because I have taken this one apart I dont know how many times.
