91ROKKRAWLER
Well-Known Member
- Joined
- December 6, 2007
- Messages
- 510
- Reaction score
- 2
- City, State
- Bend, OR
- Year, Model & Trim Level
- '91 Xploder
so i've been makin plans up, drawing, drafting, and wanting to cad some plans up. it'll be a bumper similar to whitetrash96s' but it will be a receiver bumper that will have less depth and a stinger with supports...
whitetrash96s' bumper
i built one out of cardboard and duct tape...
my question is, there is 7" from the valance panel to the top of the frame rail. the frame rail is 4-5" tall. how tall does the face and slant have to be. my face is 4" and slant is 7" at about a 35* angle. i don't have room to put the frame rails. whats the average of everyone elses face and slant measurements or is there a different way to mount it.
whitetrash96s' bumper
i built one out of cardboard and duct tape...
my question is, there is 7" from the valance panel to the top of the frame rail. the frame rail is 4-5" tall. how tall does the face and slant have to be. my face is 4" and slant is 7" at about a 35* angle. i don't have room to put the frame rails. whats the average of everyone elses face and slant measurements or is there a different way to mount it.
