Hello everyone,
I would like to start a thread for modified 3rd Gen Explores. I have looked everywhere and have not found one specifically on this subject. I hope im not alone on this one.
I have a 2002 Eddie and these are my mods:
custom cold air intake
JBA headers
no cats
Borla cat back
bored block .020 over
JE 9.3 CR forged pistons
Eagle H-Beam rods
AED roots ported M90 9psi supercharger
stock limited slip diffs with 3.73's
SCT flash
30lbs injectors
70mm throttle body
Eibach springs
Monro gas adjust shocks
Im building this now and should be done in about two weeks.
VERY near future mods are:
4.10's
2,800 stall converter
MAYBE relay to turn off AWD for the hard launches
42lbs injectors
250 fuel pump
70mm L-MAF
Noszle 100hp shot
Later this year mods:
ported and polished heads
bigger valves stronger springs
OR
do the same to a 3v head conversion and use a different blower.
Im hoping that with the mods I will have in the next two weeks to be somewhere in the 13's.
Maybe with the future mods dip into the 12's.
I have no idea what to expect with E/T's. Im hope there are people out there that have experimented with 3rd gen explorers and can give us some feed back and what they have found, along with maybe your related finding on hits and misses. But im DIEING to read what E/T's people are now pulling in 3rd gen Explorers...
Hope this thread sparks like wild flowers!!!