I went back out to check again. My EXP said my **was at 30 still, after I changed it. So I changed it to 32 again and made sure.
There were no changes in the settings menu on the left IPC, so I changed it back to 30 (the original sum).
There is another setting in the IPC module, IPC 720-02-02, xxxx **zz, I have FD, changed to FE (enabled with climate control and heated steering wheel), but I received an error message, that sum could not be written.
I think his sheet is wrong as there is no option for FE on the F150 forscan list. Im using AB right now because there are no heated seats or steering wheel on my XLT.
I think I figured it out though, it is 733-07-01 that is important and this isn't even in my As-Built file from Ford for some reason.
Basically XXxx xxYY are the important values.
YY was default set to 70, which is 22*C for MyTemp or about 72F.
XX was default set to 10 (I think).
In FORScan if you use the normal HVAC configuration (not the As Built) you see several options: Driver / Pass seat heater, Steering Wheel Heater, Rear Defroster, and then the Remote Start Front Defrost, Remote Start Heater A/C, and Remote Start Quiet HVAC.
The RS Front Defrost and Quiet HVAC should be ON. But the RS Heater A/C doesn't seem to mean what it means. If I turn this ON, it changes the IPC menu for RS Climate to "Last Setting". When I turn it to Auto, it changes the As-Built value to RS Heater A/C Off.
Keep in mind my XLT is a 200A, so no touch screen, no EATC/auto HVAC system, no heated wheel/seats, etc...
It looks like I have to keep the Rear Defrost FORScan setting to ON in order for it to run during remote start. But during my testing, I found that the manual HVAC still adjusts to match the "My Temp" setting regardless of my temperature control knob. I had it on full cold with max fan, and during remote start it was blowing at a lukewarm temperature close to what I'd say is 72F with the A/C compressor running.
But the rear defrost seems to stay on after a remote start. I don't see any other settings that would shut it off after a remote start.