Trans over pressure

[DOPPELGANG4]

My X got stranded a while back and I finally got it towed home. It refuses to move in any gear. It went out like a switch was flipped, drove it to work but after work it acted sluggish a couple minutes then just failed. Now I checked the fluid level (hot) and it's good, so I checked to main pressure port on the driver's side to find every gear is way too high. I'm thinking the valve in the pump is bad? I wanted to get some opinions before I pull it out of the truck

 

[410Fortune]

Was the of light flashing?
Do you have a check engine light?
Any transmission related trouble codes? These would be accesses with a scanner looking for manufacture specific codes

How many miles on this rig?
Is it 4wd?

When in limp mode the od light will flash and the trans will run at full line pressure

Line pressure is controlled by the epc solenoid

Was the
Fluid burnt?