Completed Project Burns SAS thread

[section525]

I meant IZWack. That kid is siiiick.

 

[IZwack]

Look at the junk yards for the flat-tops .. also check out PBB and E-bay. I got mine from a guy on PBB for ~$75. Of course, as flat tops come from the factory, only one side is set up for hi-steer so you have to get the other side machined, drilled and tapped -- which typically costs between $40 and $70

 

[IZwack]

I meant IZWack. That kid is siiiick.

I are not running the Sky flat top knuckles - tho I am running their arms .

 

[Burns]

either way i found some relativly priced so im good.

 

[IZwack]

either way i found some relativly priced so im good.

 

[Burns]

Well who would have guessed that the day explorer forum goes down my stinking transfer case goes out. i will not work in 2hi,4hi but will work in 4lo. not sure about that but i have spent the rest of today changing the cases out and now i dont have a spare.

 

[FROADER]

Well that's why you had the spare in the first place. That sucks but at least you're already up and running.

 

[Burns]

yeah it took forever to find a trailer to get it on. i used a 16foot car trailer.


oh yeah has anyone had one of these apart u want to fixe it cause i have another one from a ranger that went out and i might be able to make one out of two

 

[IZwack]

i have spent the rest of today changing the cases out and now i dont have a spare.

Oh you do you just have to fix it first. Just open it up, its cake after that

 

[Burns]

sweet i didnt think it would be that bad. i think the main shaft is messed up in the one that just messed up.

 

[IZwack]

perhaps a bent/almost broken shift fork .. either way, its fun

 

[Burns]

yeah we are sure its on the main shaft. never know till u try and im gonna.

 

[Burns]

Sport Truck mag

Some new info other than the broken tcase is that my explorer is in sport truck mag. it was when i was a slammin and jammin. its a nice size pic. im excited even though it was not in a 4x4 mag.

 

[FROADER]

Sweet, congrats!

 

[Burns]

that is truely the cleanest that truck has been. that was back when i just finished my sas.

 

[ld50]

hey Burns, do you know the measurement of your coil springs with the weight on them?- if ya don`t mind my askin`. Can`t seem find mention of that in the thread, but may have missed it. My apologies if you did tell us already.

-thanx

 

[Burns]

hey Burns, do you know the measurement of your coil springs with the weight on them?- if ya don`t mind my askin`. Can`t seem find mention of that in the thread, but may have missed it. My apologies if you did tell us already.

-thanx

i never bothered to check but i will right now. y would you want to know that

 

[Burns]

they are 15 1/2 inches sitting level in the garage.

 

[ld50]

It tells me exactly how much the front end weight of a 1st gen Explorer squarshes a set of wild horse 5.5 inch coils. So if I wanted to run those above the d44 I`m installing; I set the axle the right amount off the ground, set the truck at the height I would like it to sit at with springs compressed, measure 15.5 inches up from the coil seats, and install my coil buckets accordingly.

invaluable measurement, thanks for doin that!

 

[Burns]

no prob.